*This product is tested only with Windows-PC.
*This product is tested only with Poser. ( NOT tested with "DAZ|Studio" )
Product Requirements:Poser9/PoserPro2012 or later / PC Only
motion_dial of "SWN357_C01"
>trigger_pull
forward or back the trigger
*it doesn't synchronize with the hammer.
>hammer_cock
cock or release the hammer
*it doesn't synchronize with the trigger.
>bolt_forward/back
forward or back the cylinder release bolt(and Thumbpiece)
>safety_key_lock
lock or unlock the safety-lock
>locking_bolt_forward/back
forward or back the locking-bolt
>yoke_swing-out
the cylinder is taken out to left-side
>cylinder_rotate
rotates the cylinder( When the value:1, it rotates by 45 degrees. )
>ejector_push
forward or back the ejector
>center_pin_forward/back
forward or back the cylinder-center-pin
>cylinder_stop/Down
up or down the cylinderstop-latch
*it doesn't synchronize with the trigger.
>MPR8_barrel_rail
This item is effective, only when you applied SWN357-MAT05(MPR8).
0. Barrel-Top-Rail is non-displayed.
1. Barrel-Top-Rail is displayed.
>VC5_barrel_muzzle
barrel are changed from 0 to 2
0. Muzzle-brake is displayed.
1. Muzzle-cap is displayed.
2. Muzzle-brake or Muzzle-cap is non-displayed.
Software:
Poser 10 / Poser Pro 2014 +, Poser 9 / Poser Pro 2012 +
