Starship Bridge XT for Poser. Product Features:
* Includes two Poser figures (.obj, .cr2/ .png)
- Bridge XT room, at approx 214,649 polygons.
- Executive Chair, at approx 14,979 polygons.
Bridge Room:
* Poser figure (obj, cr2/ png), at approx 214,649 polygons.
* As is usual for our Starship Bridges, all walls (and the ceiling) can be hidden for easier camera placement.
* Lift door can open and close, with an ERC dial on the Body.
* Helm chair can rotate around, with an ERC dial on the Body.
* Helm console can rotate, with an ERC dial on the Body.
* Two sets of left front doors can open and close, with an ERC dial on the Body.
* Two sets of right front doors can open and close, with an ERC dial on the Body.
* Two sets of left rear doors can open and close, with an ERC dial on the Body.
* One set of right rear doors can open and close, with an ERC dial on the Body.
* An ERC dial on the Body moves the Science and Tactical chairs on the "track".
* The side bridge chairs are separate body parts which can be repositioned to suit the needs of your scene.
* Includes the captain's ready room off the rear of the bridge.
Chair Features:.
* The back can bend, with an ERC dial on the Body.
* The bottom can rotate, with an ERC dial on the Body.
* The Bridge XT cr2 file already has the chair in place, so you don't need to add it to the scene.
* Since the chair is a separate figure, you can add more to the scene or use it in other room sets.
Textures:
* One color scheme for all the monitor displays is included.
Poses:
* Hide/ show poses for each wall and the ceiling, for both the bridge and hallway.
Cameras:
* Fourteen camera files are included.
* The camera files also hide any walls which may be blocking the camera.
You can use these camera angles to render your scenes or use them as a starting point and adjust them as needed.
Designed for use in Poser 5 and above.
This product has not been tested in DAZ Studio, but it was designed to be Studio-friendly.
The product includes a separate cr2 file with the doors are set to the "open" position, which should avoid any vertex-welding issues.
Software: Poser 6+
