Victoria 4.2 Everyday poses - Xpansion package C - by 3D-Mobster 2014
Product Description
----------------------------
Xpansion package C - Vigilant expand the series with four new main categories with 8 poses in three of them and 6 in the last one. Two of the poses in the sleeping
category are for getting in and out of bed.
Also some poses although they are original made for sleeping/getting in/out of a bed they should work for any surface that are either flat,
such as ground or boxed shaped and others should be easy to adjust to also fit objects with an edge like a wall or cliff.
Some sneaking poses are created to be used against a wall shaped object. The library images will show how the poses was original meant to be used.
File are structured into the following categories
--------------------------------------------------
Pointing (Total 8 Poses and 8 between poses)
Presenting (Total 8 poses and 8 between poses)
Sleeping (Total 8 poses and 8 between poses)
Sneaking (Total 6 poses and 6 between poses)
----------------------------------------------------
Total number of poses: 30 poses and 30 between poses.
----------------------------------------------------
General information for the Everday poses series
------------------------------------------------
All poses have been created with dynamic cloth in mind, therefore all of them also have "in between" pose(s) which can be added
between the start default pose and the end pose. Since dynamic cloth is calculated through the cloth room, situations might occur where some poses might not
give good results with certain type of cloth. The between poses are only meant as a default in between pose and should be modified to suit your needs if problems occur,
if your cloth calculate fine without the in between poses there are no need to use them, they are only there to make it faster to work with the dynamic cloth.
The poses can of course also just be used normally without dynamic cloth objects.
The poses was created for victoria 4.2 however they will work fine for Victoria 4, just beaware that some minor correction of hands and fingers might be needed.
Have been tested on Michael 4 and seems to work for him as well, however there are no guarantee that they will be correct as the poses weren't created for that
character.
-- IMPORTANT --
Be sure that "Use inverse kinematic" in "Figure" menu is turned off before you apply the poses or weird bending and twisting can occur. After applying the poses
you can turn them on again if needed.
----------------------------
System Requirements
----------------------------
Any poser/Daz3d that can use Victoria 4.
Ownership statements
----------------------------
"All of the content in this package was created by 3D-Mobster"
Needed Files
----------------------------
Character Victoria 4 / 4.2 is needed.
Installation instructions
----------------------------
Unpack the Zip archive(s) to your poser runtime directory, all files will be placed in the right folders.
And follows the standard folder hierarchy of Poser.
Software:
Poser 6, Poser 7, Poser 8, Poser 9, Poser Pro 2010, Poser Pro 2012, Daz Studio 4.5, Daz Studio 3, Poser 10, Poser Pro 2014, Daz Studio 4.6
Base Figures: Victoria 4
Digital ProductFile (1): 745.75 KB
